Ultisensor Electronics

Send Email>> 中文版>> Buy Online>>
Current Location:Home > 1/2" Hall Flow Sensor > USC-HS21TLT with Immersion Temperature Sensor

USC-HS21TLT with Immersion Temperature Sensor

Author：ultisolar / Date：2015-11-2 / Views： Times

 

Application:

Water heater, washing machine, boiler, electromagnetic water heater, water dispenser, water purifier, R.O. machine, U.F. machine, coffee machine, water machine, water machine control, water control machine, beer machine, beauty equipment, shower equipment, electrolytic water machine, energy engineering, heat pump,IC meter, steam equipment, irrigation equipment, water system, campus card self-service sale (sell) water machine, washing machine, automatic washing equipment, water treatment equipment, water dispensing equipment, cooling system, circulation system, intelligent toilet (toilet), bidet, mechanical equipment, heating equipment,  Pharmaceutical (agents) equipment etc.

Calculation Formula: F(Hz)= 10*flow rate(Q)(l/min)
The temperature sensor can be NTC10K (B=3435/ B=3950), NTC50K, PT1000, PT100 etc.
Note:
1. When magnetic material is close with the sensor, its characteristics may vary.
2. In order to avoid particle debris, the sensor must be installed after a filter.
3. The flow sensor installation has to avoid strong vibration and shaking of the environment, so as not to affect the sensor's measurement accuracy.
Features:
4.       Copper material, environmental friendly material, small, flexible and functional.
5.       Intubation design of inlet and outlet pipe, easy connection and operation;
6.       Imported Hall IC from Japan, stable and reliable;
7.       Range: 1-30L/min;
8.       working voltage: DC4.5-18V; (24v is available MOQ 10pcs)
9.       rated voltage: DC5V;
10.   Output voltage(rated: DC 5V); High level 4.5V and above; low level 0.5V and below
11.   Pulse output duty cycle: 50+-10%
12.   Insulation resistance: 100M Ohm and above;
13.   Tightness: Seal up all the holes, and inflate with 1.7MPa water, after 1 minute, no leakage and deformation;
14.   -20-60 centigrade;
15.   One year warranty

 Note:

1.  When  magnetic material is close with  the sensor,its characteristics may vary.
2.  In order to avoid particle debris, the sensor must beinstalled after a filter.
3. The flow sensor installation  has to avoid strong vibration and shaking of the  environment, so as not to affect the sensor's measurement accuracy.

 

Last Post：
Next Post：

  • Category

Ultisolar Group:  Ultisolar.com -|-Ultisensor.com -|-Online Shop

Copyright © 2010 Ultisensor Electronics All rights reserved.

鲁ICP备17032917号-5 Powered by Z-blog